Chemicals For Printed Circuit Boards

Product Details:

Protecot (Protective Coating). It is a rosin based coating developed to preserve the solderability of printed circuit boards by protecting clean metallic surfaces from atmospheric oxidation and other contamination. It can be applied by spraying, dipping or brushing to a circuit board which has been cleaned and water rinsed.

Additional Information:

• Item Code: PROTECTIVECOATING
• Production Capacity: 250-Ltrs
• Delivery Time: 7-days
• Packaging Details: Plastic Jerry can

Product Details:

Solder Conditioner-1410. It is an acid base chemical cleaner for cleaning and conditioning tin/lead plated surfaces. It removes ammonia salt residues formed during alkaline etching. It can also be used as a pre-soldering cleaner to improve solderability by removing from PC boards the oxides formed during storage.

Additional Information:

• Item Code: 1410
• Production Capacity: 500
• Delivery Time: IMMEDIATE

Product Details:

Flux-357-E(HAL).  It is a low viscosity organic liquid formulation developed for solder coating of printed circuit boards by hot air leveling equipment.

Additional Information:

• Item Code: 357EHAL

Product Details:

RACOT (Synthetic Protective Coating):
It is a Synthetic Coating to preserve the cleaning surfaces of metallic parts of any shape or PC Boards surface from atmospheric oxidation and other contamination. It can be applied by spraying, dipping or brushing.

APPLICATION:
RACOT is applied by spraying, dipping or brushing to a circuit board which has been cleaned and water-rinsed.
DRYING :
RACOT has a moderate evaporating solvent system and requires oven drying. Only mild heat should be used since excessive heating will polymerize the coating and inhibit its flux assisting quality. The solvent is evaporated by heating in a circulated air oven at 200-300F for 1-2 minutes. A cool blast of air such as from a fan will set the warm surface and provide a hard, tack free coating

THINNING : Only minimal thinning is required to maintain the proper solids content. ICM-ThinnerRCT should be used for thinning
SAFETY AND PRECAUTIONS: Protective solves and goggles are recommended during handling. Adequate ventilation should be provided. Direct heating, spark and flames should be avoided.

Additional Information:

• Item Code: RACOT
• Delivery Time: IMMEDIATE

Product Details:

ROLL Tinning Salt (RT-861). It is a whitish granular powder. It contains halogens and surfactant. It provides a fluxing action enhancing the solder spread during the roll tinning and also functions as a dross reducer. 

Additional Information:

• Item Code: RT861
• Production Capacity: 100-kgs
• Delivery Time: IMMEDIATE
• Packaging Details: Plastic jar

Product Details:

Soldering Flux-103.It is a water soluble organic activated flux. It is especially adaptable for foam fluxing, however, it can also be applied by dipping or brushing. It is used where inorganic fluxes are too corrosive to use and rosin fluxes are too inactive for the application. It is essential that the flux residues be completely and adequately removed. Normally DI water is used for such cleaning. The flux is also designed for roll tinning of PC Boards. ICM Roll Tinning Salt.(item code: 861) is used along with it.

Additional Information:

• Production Capacity: 500-Ltrs
• Delivery Time: 7-days
• Packaging Details: Plastic Jerry can